How to Install Car Warp Vinyl

---

Car Wrap Vinyl Installation:

Step 1:

Wash a car by hand with soap and water. Don’t go to the car wash and power wash the vehicle.because car washes will still leave a film and small dirt particles.

Step 2:

wipe down the vehicle with a solution of 50% water and 50% rubbing alcohol to help strip away any wax residue and grease.

Step 3:

Wrap should be done indoors if possible. This will limit a wind gusts and dirt particles from inhibiting your installation. The ideal temperature to apply the wrap should be between 60 and 90°

Step 4:

Trim the car wrap vinyl to fit this section of car you were working on.

Step 5:

Place the back matte vinyl on the car. Remove the backing carefully and do not allow the wrap to stick to itself. Start at a corner and began applying the wrap slowly. Rub back and forth across the wrap with hands to help eliminate air bubbles and wrinkles.

Step 6:

Using a plastic squeegee to let the air bubbles out from the middle of the black matte vinyl towards the edges.